Real-time cargo route adjustments

List of the catalog of this article:

• 1. What should I do if the engine speed can't be turned up?
• 2, What's wrong with the engine speed not going up?
• 3, The engine fault light of the high-speed car just finished running turned on. The car felt weak, and the tachometer was about 60...
• 4, start The engine speed can't go up

What should I do if the engine speed can't be turned up?

It may be that there is a problem with the throttle valve. First, check whether the throttle position sensor is normal, and sometimes it trembles when refueling; it may also be that the engine cylinder is missing, and the spark plug is not well ignited, just replace the spark plug; and it may also be one of the three problems: oil line, oil pump and gasoline grid. The question is answered.

It is recommended to go directly to the repair point to check and repair. There are many factors that cause the speed of the car's refueling door to not be accelerated. ( 1) It is possible that the throttle position sensor is too dirty or the voltage imbalance will cause the electronic throttle failure to cause the throttle to step up the speed.

After the engine is started, even if it runs well from low speed to high speed, if the ignition is turned off immediately after releasing the accelerator pedal or the engine is unstable before turning off, idling stop failure will also occur.

What's wrong with the engine speed not going up?

1. Three possibilities (1) Check the oil line, especially the gasoline pump. It is possible that the oil is of poor quality or the fuel tank is too dirty, and the oil line is blocked. It can be solved by cleaning the fuel tank and replacing the gasoline pump core. ( 2) Check the distributor.(3) Check the cylinder pressure. The latter two are not as likely as the other.

2. Hello, there is a large energy loss in the power transfer between the engine and the transmission; there is a problem with the clutch and the transmission; there is a problem with the output shaft and the meshing gear of the gear. The car engine is a device that powers the car. It is the heart of the car and determines the power, economy, stability and environmental protection of the car.

3. The reason for the clutch. Manual transmission, dual-clutch transmission, semi-automatic transmission and other forms of transmissions all use friction disc clutch to transmit the power of the engine. If the pressing torque is insufficient or the friction disc is seriously worn, slippage will occur, resulting in the high speed of the car.

4. The speed of the car goes upIf the speed of the car cannot be accelerated, this situation is generally caused by the failure of the transmission. The most common phenomenon is the slippage of the transmission, and it may also be affected by the serious wear or even burning of the clutch or brake friction pads.

5. It is possible that the throttle position sensor is too dirty or the voltage imbalance will cause the electronic throttle to fail, and the speed of the accelerator cannot be increased. In the three systems of the engine's air intake, oil route and ignition, if any part of one of the system fails or is abnormal, it may cause the car to step on the accelerator and the speed cannot be up.

The engine fault light of the high-speed car just turned on. The car felt weak, and the tachometer was around 60...

It is possible that the deviation of the vehicle tires caused the speed detected by the wheel speed sensor to be different. It was judged that one side of the tire was slipping, limiting the speed to increase the torque.

Why does the engine light turn on when driving at high speed? When driving at high speed, the owner is still worried about engine failure, but sometimes it is still difficult to avoid these accidents.

The specific reasons why the engine alarm light is on are as follows: sensor problems: sensors include water temperature, crankshaft position, air flow, intake temperature, oxygen sensor, etc. When these sensors are damaged, poor contact or signal interruption, the ECU of the car cannot accurately obtain the engine data. At this time It will cause the engine fault light to light up.

The specific analysis is as follows; sensor problem; the sensors mentioned here include water temperature, crankshaft position, air flow, intake temperature, oxygen sensor, etc. When these sensors are damaged, poor contact or the signal is interrupted, the ECU of the car cannot accurately obtain the engine data, and at this time it will Cause the engine fault light to turn on.

Engine speed can't go up

1. The following are the reasons why the speed cannot be accelerated: the fuel filter is blocked: The maintenance personnel found that the shell of the fuel filter was relatively dilapidated and obviously not been replaced for a long time. If the internal filter material of the fuel filter is not replaced for a long time, it will gradually be blocked by impurities in the fuel, resulting in insufficient fuel circulation.

2. The fuel filter is blocked. If the fuel filter is not replaced for a long time, the internal filter material will gradually be blocked by the impurities in the fuel, resulting in insufficient fuel circulation.

3. Clean up the oil pump and replace the genuine filter, generally fine. The oil-water separator and diesel filter element are seriously blocked, and the flow rate of diesel in the whole oil line is actually extremely small. Under such circumstances, the engine can only be started, and it is almost impossible to achieve greater performance.

4. The reason why the engine speed cannot be accelerated: there is a large energy loss in the power transfer between the engine and the transmission; there is a problem with the clutch and the transmission; the problem with the output shaft and the meshing gear of the gear.

5. What's wrong with the engine speed not speeding up? It may be that the throttle position sensor is too dirty or the voltage is unbalanced will cause the electronic throttle to fail, and the throttle cannot be up at full speed.